HEADLIGHT BEAM ADJUSTMENT
Switch 1 is used to adjust the height of the headlight beams according to the load.
With the dipped beam headlights lit, press or lift switch 1 as many times as is necessary to select the required position on the instrument panel.
Note: depending on the vehicle, each time the ignition is switched on, the position selected is displayed on the instrument panel for approximately 30 seconds and for approximately 5 seconds each time switch 1 is pressed.
Examples of positions for adjusting control 1 according to the load | |
---|---|
Driver alone or with front passenger | 0 |
All seats occupied | 1 |
Driver with passengers and luggage (or load) reaching the maximum permissible all-up weight | 3 |
Driver without passengers and luggage (or load) reaching the maximum permissible all-up weight | 4 |
The table below gives some examples. In all cases, adjust control 1 according to the vehicle load so that the road can be seen and other drivers are not dazzled. |