REAR LIGHTS: changing bulbs
Depending on the vehicle, open the hinged doors or the tailgate.
Undo bolts 1 using a Torx tool.
Unclip the lower section, then the upper section of the light by pulling it towards you.
Pull tabs 2 to unclip bulb holders 3.
Replace the bulb, then proceed in the reverse order to refit the bulb.
Pear-shaped, bayonet type bulb P Y21W.
5 Side and brake light
Pear-shaped, bayonet type bulb with two filaments P 21/5W.
6 Reversing light
Pear-shaped, bayonet type bulb P 21W.
The bulbs are under pressure and can break when replaced.
Risk of injury.
High-level brake light
- Version with tailgate: it is located above the rear screen, in the centre.
- Version with hinged doors: it is located above the rear screen, on the left-hand door.
Remove the two plastic blanking covers 7 from the inside. Unclip the light using a screwdriver, by pressing in the metal clip housings.
Remove light 8 from the outside. Replace the bulb without disconnecting the wiring.
Bulb type: W16W
For refitting, proceed in the reverse order to removal.
Check the tabs are correctly locked in position.
Number plate light
Undo two bolts 9 using a Torx tool.
Release the light 10 to access bulbs.
Bulb type: W5W.
Replace the bulbs, then fit the light in position.