Back to the list

REAR LIGHTS: changing bulbs

  • 1
  • 2
  • 3
  • 4
  • 5

Rear lights

Depending on the vehicle, open the hinged doors or the tailgate.

Undo bolts 1 using a Torx tool.

Unclip the lower section, then the upper section of the light by pulling it towards you.

Pull tabs 2 to unclip bulb holders 3.

Replace the bulb, then proceed in the reverse order to refit the bulb.

Bulb type

4 Indicator

Pear-shaped, bayonet type bulb P Y21W.

5 Side and brake light

Pear-shaped, bayonet type bulb with two filaments P 21/5W.

6 Reversing light

Pear-shaped, bayonet type bulb P 21W.

The bulbs are under pressure and can break when replaced.

Risk of injury.

High-level brake light

- Version with tailgate: it is located above the rear screen, in the centre.

- Version with hinged doors: it is located above the rear screen, on the left-hand door.

Remove the two plastic blanking covers 7 from the inside. Unclip the light using a screwdriver, by pressing in the metal clip housings.

Remove light 8 from the outside. Replace the bulb without disconnecting the wiring.

Bulb type: W16W

For refitting, proceed in the reverse order to removal.

Check the tabs are correctly locked in position.

Number plate light

Undo two bolts 9 using a Torx tool.

Release the light to access bulbs 10.

Bulb type: W5W.

Replace the bulbs, then fit the light in position.