Back to the list

DRIVER’S SEAT WITH ELECTRIC CONTROLS

  • 1
  • 2
  • 3
  • 4
  • 5

On equipped vehicles, switch 1 grants access to the seats menu on the multifunction screen (please refer to the following pages).

Adjusting the seatback

To tilt the seatback, move the top of switch 2 forwards or backwards.

Adjusting the lumbar support on the seat

Move the switch 3 forwards, backwards, up or down.

Make sure that the seatbacks are correctly locked in place.

For safety reasons, carry out any adjustments when the vehicle is not being driven.

Make sure that the seatbacks are correctly locked in place.

We would advise you not to recline the seatbacks too far to ensure that the effectiveness of the seat belts is not reduced.

No object should be placed on the floor (in front of the driver). such objects may slide under the pedals during sudden braking manoeuvres and obstruct their use.

Adjusting the seat position

To move the seat forwards or back

Move switch 4 forwards or backwards.

To raise or lower the seat base

Move the back of switch 4 up or down.

To tilt the seat base

(depending on the vehicle)

Move the front of switch 4 upwards or downwards.

Adjusting the seat length

Lift handle 5 to unlock. Release the handle at the desired position and make sure that it is locked.

Heated seats

With the ignition on:

- pressing the switch 6 on the relevant seat for the first time activates the heating system on high. Both integrated switch warning lights come on. The system automatically decides whether or not the heating is needed;

- pressing the switch for the second time changes the heating to low. One integrated warning light comes on;

- pressing for the third time turns the heating off.

Operating faults

When an operating fault is detected, the warning lights in the switch 6 for the seat concerned flash or, depending on the vehicle, switch off after approximately five seconds.

Consult an approved dealer