Headlight beam adjustment
Headlight beam adjustment
Depending on the vehicle, the switch A can be used to adjust the height of the headlight beams according to the load.
With the dipped beam headlights on, press or raise switch A as many times as required to select the required position on the instrument panel.
Note: if the lights are on, at each engine start-up the selected position is displayed
on the instrument panel for approximately 15 seconds.
Examples of positions for adjusting the switch A according to the load | |
Driver alone or with front passenger | 0 |
All seats occupied | 1 |
Driver with passengers and luggage (or load) reaching the maximum permissible all-up
weight | 3 |
Driver without passengers and luggage (or load) reaching the maximum permissible all-up
weight | 4 |
The table below gives some examples. In all cases, adjust the control A according to the vehicle load so that the road can be seen and other drivers are
not dazzled.
Tip
When driving on the left-hand side of the road in a left-hand drive vehicle (or vice
versa), you must adjust your headlights for the length of your stay.
Temporary adjustment
This can be adjusted using the multimedia screen. Please more information, please
refer to the multimedia user manual.
Depending on the vehicle, open the bonnet and identify the marking B near one of the headlights.
Using a screwdriver or similar tool, turn the bolt 1 by three quarters of a turn towards the - to lower the beams.
Return to the original position once your trip is over: turn the bolt 1 by three quarters of turn towards the + to raise the beams.
