Headlight beam adjustment

  • 1
  • 2
  • 3
  • 4
  • 5

Headlight beam adjustment

Switch A is used to adjust the height of the headlight beams according to the load.
With the dipped beam headlights on, press or raise switch A as many times as required to select the required position on the instrument panel.
Note: depending on the vehicle, when the engine is started, the position selected is displayed on the instrument panel for approximately 30 seconds and for five seconds each time switch A is pressed.

Table of adjustment position examples

 
Examples of positions for adjusting the control A according to the load
 
Petrol version only
E-Tech Full Hybrid version
Driver alone or with front passenger
0 or 1
0 or 1
All seats occupied
1 or 2
1 or 2
Driver with passengers and luggage (or load) reaching the maximum permissible all-up weight
2 or 3 or 4
2 or 3
Driver without passengers and luggage (or load) reaching the maximum permissible all-up weight
3 or 4
3 or 4
 
The table below gives some examples. In all cases, adjust the control A according to the vehicle load so that the road can be seen and other drivers are not dazzled.