Back to the list

Changing a wheel

  • 1
  • 2
  • 3
  • 4
  • 5

Changing a wheel

WARNING
Switch on the hazard warning lights.
Keep the vehicle away from traffic and on a level surface where it will not slip.
Apply the parking brake and engage a gear (first or reverse, or P for automatic transmissions).
Ask the passengers to leave the vehicle and to keep away from traffic.

Vehicles equipped with a jack and wheel brace

If necessary, remove the wheel trim.
Unlock the wheel bolts using the wheel brace 1. Position it so as to be able to push from above.
Place the jack 2 horizontally: the jack head must be lined up with the sill closest to the wheel concerned, as indicated by the arrow 3.
WARNING
If the vehicle is parked on the hard shoulder, you must warn other road users of your vehicle's presence with a warning triangle or with other devices as per the legislation applying to the country you are in.
Start cranking the jack by hand, positioning the jack support plate 4 in the slightly indented groove underneath the vehicle, located underneath the vehicle sill, 5 and in the direction indicated by the arrow 3.
Continue to crank the jack so that the baseplate is correctly positioned (it should be underneath the vehicle and aligned with the jack head).
Turn it a few times to lift the wheel off the ground.
Undo the bolts and take off the wheel.
Fit the emergency spare wheel on the central hub and turn it to locate the mounting holes in the wheel and the hub.
Tighten the bolts, checking that the wheel is correctly positioned on its hub.
Lower the jack.
With the wheel on the ground, tighten the bolts fully and have the tightness of the bolts checked and the emergency spare wheel pressure checked as soon as possible.
WARNING
If you have a puncture, replace the wheel as soon as possible.
A tyre which has been punctured should always be inspected (and repaired, where possible) by a specialist.
Vehicle fitted with a tyre pressure loss warning system
In the event of under-inflation (puncture, flat tyre, etc.), the warning light appears on the instrument panel TYRE PRESSURE LOSS WARNING.
WARNING
Do not leave the tools unsecured inside the vehicle as they may be projected during braking. After use, check that all the tools are correctly clipped into the tool kit, then position it correctly in its housing to reduce any risk of injury.
If bolts are supplied with the emergency spare wheel, you must use these bolts only for the emergency spare wheel.
WARNING
For safety reasons, the use of a jack not recommended by the manufacturer is strictly forbidden.
The jack is specific to the vehicle and used to change the wheels.
Under no circumstances should it be used:
  • on another vehicle;
  • to carry out a repair;
  • to access the underside of the vehicle.
Risk of injury.
Risk of damage to the vehicle.