Back to the list

Wheel trims, wheel trim – wheel

  • 1
  • 2
  • 3
  • 4
  • 5

Wheel trims, wheel trim – wheel

Central wheel trim 3

Remove the wheel trim using the hubcap tool 1 (located in the tool kit) by fitting the hook into the notch 2 on the central trim 3.
To refit the central trim 3, position the four central trim mountings in the notches of the rear trim. Firmly press the central section to engage the central trim 3.

Rear trim

Remove it using the hubcap tool 1 (located in the tool kit) by engaging the hook in the opening near the valve 2.
To refit it, align it with the valve 2.
Push the retaining hooks in fully, starting on the side of valve A, followed by B and C, finishing at the side opposite valve D.
WARNING
Do not leave the tools unsecured inside the vehicle as they may be projected during braking.
After use, check that all the tools are correctly clipped into the tool kit, then position it correctly in its housing to reduce any risk of injury.