HEADLIGHT BEAM ADJUSTMENT

Switch A is used to adjust the height of the headlight beams according to the load.
With the dipped beam headlights lit, press or lift switch A as many times as is necessary to select the required position on the instrument panel. The position selected is displayed on the instrument panel for approximately 30 seconds.
Note: depending on the vehicle, at each engine start-up the selected position may be displayed on the instrument panel for approximately 30 seconds.
Examples of positions for adjusting control A according to the load |
|
---|---|
Driver alone or with front passenger |
0 |
All seats occupied |
2 |
Driver with passengers and luggage (or load) reaching the maximum permissible all-up weight |
3 |
Driver without passengers and luggage (or load) reaching the maximum permissible all-up weight |
4 |
The table below gives some examples. In all cases, adjust control A according to the vehicle load so that the road can be seen and other drivers are not dazzled. |