RUNNING IN, IGNITION SWITCH

  • 1
  • 2
  • 3
  • 4
  • 5

Petrol version

For the first 600 miles (1,000 km), do not exceed 80 mph (130 km/h) in the highest gear, or 3,000 to 3,500 rpm.

You may only expect top performance from your vehicle after approximately 1,800 miles (3,000 km).

Service intervals: refer to the Maintenance Service Booklet for the vehicle.

Diesel version

For the first 1,000 miles (1,500 km), do not exceed 80 mph (130 km/h) in the highest gear, or 2,500 rpm. After completing this mileage you may drive faster, although you may only expect top performance after approximately 3,600 miles (6,000 km).

During the running in period, do not accelerate hard while the engine is still cold and do not let the engine over-rev.

Service intervals: refer to the Maintenance Document for your vehicle.

Note: for a new vehicle in the running-in phase: the coolant level may be higher than the “MAXI” mark on the tank, then drop to between the “MINI” and “MAXI” marks.

This does not present a risk.

Off position A (steering lock applied)

To lock: remove the key 1 and turn the steering wheel until the steering column locks.

To unlock: turn the key and the steering wheel slightly.

“Accessories” position B

When the ignition is switched off, any accessories (radio, etc.) will continue to function.

“Ignition” position C

The ignition is switched on:

- Petrol version: the engine may be started.

- Diesel version: the engine is preheating.

“Start” position D

If the engine fails to start at the first attempt, the key must be turned back before the starter can be activated again.

Release the key as soon as the engine starts.

Note: on diesel versions, several seconds may pass between turning the key and the engine starting to allow for engine preheating.