Back to the list

ELECTRIC WINDOWS

  • 1
  • 2
  • 3
  • 4
  • 5

Electric windows

These systems operate with the ignition on or off, until one of the front doors is opened (limited to about 3 minutes).

Press the switch for the window concerned to lower it to the desired height.

Lift the switch to raise the window to the desired height.

From the driver’s seat

Operate the switches as follows:

- 1 for the driver’s side;

- 2 for the front passenger’s side;

- depending on the vehicle, 3 and 5 for the rear passengers.

Safety of rear occupants

The driver can prevent operation of the rear electric windows by pressing switch 4. A confirmation message is displayed on the instrument panel.

Driver’s responsibility

Never leave your vehicle with the card or key inside, with a child, adult who is not self-sufficient or a pet in the vehicle, even for a short while.

They may pose a risk to themselves or to others by starting the engine or activating equipment (such as the gear lever or electric windows).

If any part of the body becomes trapped, reverse the direction of the window immediately by pressing the relevant switch.

Risk of serious injury.

From the front passenger seat

Press switch 6.

Avoid resting any objects against a half-open window: there is a risk that the electric window winder could be damaged.

From the rear seats

With the doors closed, press switch 7.

Half-opening window

To half-open the window, turn handle 8 in the direction of the arrow, then lock it by pushing the handle. When closing it, check that it is properly locked.

One-touch electric window

The one-touch mode works in addition to the operation of the electric windows described previously.

It is fitted to the driver’s window.

Briefly press or pull the switch 1 as far as it will go: the window will be fully raised or lowered.

Pressing the switch again while the window is moving will stop its movement.

Note: if the window detects resistance when closing (e.g. tree branch etc.), it stops and then lowers again by a few centimetres.

Operating faults

In case of a fault when closing a window, the system reverts to normal mode: pull the switch concerned up as often as necessary to fully close the window (the window will close gradually), hold the switch (still on the closing side) for one second then lower and raise the window fully to reinitialise the system.

If necessary, contact an approved Dealer.

When closing the windows, ensure that no part of the body (arm, hand, etc.) is protruding from the vehicle.

Risk of serious injury.