The speed limiter function helps you stay within the driving speed limit that you choose, known as the limit speed.
If you wish, you can associate the speed limiter and the “Overspeed alert” function. OVERSPEED ALERT
1 Main “On/Off” switch.
2 Controls for:
a speed limiter activation, memory and increase (+);
b decreasing the speed limiter (-).
3 Activation and recall of memorised limited speed (R).
4 Speed limiter function standby (with limited speed memory) (O).
Press switch 1 on side . The indicator light comes on, lit orange, and the message “Speed limiter” appears on the instrument panel, accompanied by dashes to indicate that the speed limiter function is activated and waiting to store a limited speed.
To store the current speed, press the switch 2 on side a (+): the limited speed will replace the dashes.
The minimum stored speed is 20 mph (30 km/h).
When a limited speed has been stored and this speed is not reached, driving is similar to driving a vehicle without the speed limiter function.
Once you have reached the stored speed, no effort on the accelerator pedal will allow you to exceed the programmed speed except in an emergency (refer to information on “Exceeding the limit speed”).
Varying the limit speed
The speed limiter can be changed by repeatedly pressing the switch 2:
- side a (+) to increase the speed;
- side b (-) to reduce the speed.
The speed limiter function is in no way linked to the braking system.
Exceeding the limit speed
It is possible to exceed the limit speed at any time. To do this: press the accelerator pedal firmly and fully (beyond the resistance point).
While the speed is being exceeded, the speed limiter flashes red on the instrument panel.
Then, release the accelerator: the speed limiter function will return as soon as you reach a speed lower than the stored speed.
Limited speed cannot be maintained
If driving up or down a steep gradient, the system is unable to maintain the limited speed: the memorised speed flashes red on the instrument panel and a beep sounds at regular intervals to inform you.
Putting the function on standby
The speed limiter function is suspended when you press switch 4 (O). In this case, the speed limit remains stored and the message “Memorised” accompanied by this speed appears on the instrument panel.
Recalling the limit speed
If a speed has been saved, it can be recalled by pressing switch 3 (R).
When the speed limiter is put on standby, pressing side a (+) on the switch 2 reactivates the function without taking into account the stored speed: it is the speed at which the vehicle is moving that is taken into account.
Switching off the function
The speed limiter function is deactivated if you press switch 1: in this case a speed is no longer stored. The orange warning light and message on the instrument panel goes out to confirm that the function is deactivated.