Back to the list

HEADLIGHT BEAM ADJUSTMENT

  • 1
  • 2
  • 3
  • 4
  • 5

On vehicles fitted with this function, control A allows you to adjust the height of the beams according to the load.

Turn control A downwards to lower the headlights and upwards to raise them.

For manual settings

Examples of positions for adjusting control A according to the load

0

Driver alone or with front passenger or with one front passenger and two or three rear passengers

1~2

Do not use

3

Driver with a full car of passengers, luggage or (load) reaching the maximum permissible all-up weight

4

Driver with a full car of luggage or (load) reaching the maximum permissible all-up weight

The table below gives some examples. In all cases, adjust control A according to the vehicle load so that the road can be seen and other drivers are not dazzled.

For vehicles not fitted with a control A, the headlight adjustment is automatic, depending on the vehicle load.

When driving on the left in a lefthand drive vehicle (or vice versa), you must adjust your lights temporarily during your stay.

Temporary adjustment for vehicles fitted with halogen headlights

Open the bonnet and identify the marking B next to one of the front headlight projectors.

For each headlight, using a screwdriver, turn the screw 1 by a quarter turn towards the - symbol to lower the beams.

Return to the starting point once your trip is over: turn the screw 1 by a quarter turn towards the + symbol to raise the beams.

DYNAMIC FEATURES : AUTOMATIC MAIN BEAM HEADLIGHTS

DYNAMIC FEATURES : CORNERING LIGHTS