Back to the list

LANE DEPARTURE WARNING

  • 1
  • 2
  • 3
  • 4
  • 5

Using information from the camera 1, the function warns the driver if he crosses a continuous or broken line without activating the direction indicator lights.

Location of the camera 1

Make sure the windscreen is not obscured (by dirt, mud, snow, condensation etc.).

This function is an additional driving aid. This function is not under any circumstances intended to replace the due care and attention of the driver, who should at all times be in control of the vehicle.

The lane departure warning function does not correct the vehicle’s trajectory.

With the ignition on, the function is activated by default.

Deactivating/Activating the function

To deactivate it, press the 2 switch:

- the message “Lane departure warning off” is displayed on the instrument panel A;

- the warning light disappears from the instrument panel A and is displayed in orange underneath the speedometer 3.

To activate the function, press the 2 switch:

- the message “Lane departure warning on” is displayed on the instrument panel A;

- the warning light is displayed in grey on the instrument panel A.

Operation

The function is set to notify the driver if:

- the vehicle speed is greater than approximately 37 mph (60 km/h);

and

- lines are detected.

The warning light is displayed in white on the instrument panel A to notify the driver.

Operation (continued)

The function triggers an alert if a line is crossed without the direction indicators being activated.

The function alerts the driver:

- by emitting a beep;

and

- the warning light flashes in white on the instrument panel A.

Temporarily not available

- Very fast lane departure;

- driving continuously on a line;

- four seconds approximately after changing lanes;

- tight bends;

- impaired visibility;

- activation of one of the direction indicator lights;

- strong acceleration;

-...

When the function is not available, the warning light is displayed in grey on the instrument panel A.

Conditions for non-activation of the system

The system cannot be activated when:

- the vehicle speed is less than approximately 37 mph (60 km/h);

- reverse gear is engaged;

- the field of vision of the camera is obstructed;

- the û warning light is displayed.

The warning light is displayed in grey on the instrument panel A.

Operating faults

In the event of a malfunction:

- the warning light disappears;

- the “Lane Departure Warning Check” message is displayed on the instrument panel A along with the warning light ©.

Consult an approved dealer.

This function is an additional driving aid. This function is not under any circumstances intended to replace the due care and attention of the driver, who should at all times be in control of the vehicle.

System servicing/repairs

- In the event of an impact, the camera alignment may be changed, and its operation may consequently be affected. Deactivate the function, then consult an authorised dealer.

- Any work in the area where the camera is located (repairs, replacements, windscreen modifications etc.) must be carried out by a qualified professional.

Only an authorised dealer is qualified to service the system.

In the event of system disturbance

Some conditions can disrupt or damage the operation of the system, for example:

- a complex environment (tunnel etc.);

- poor weather conditions (snow, hail, black ice etc.);

- poor visibility (night, fog etc.);

- road markings which are worn, lacking in contrast or very widely spaced from one another (lines partially erased etc);

- being dazzled (glaring sun, lights of vehicles travelling in the opposite direction etc.);

- the road is narrow, winding or undulating (tight bends etc.);

- closely following a vehicle travelling in the same lane.

Risk of false alarms or absence of warnings