ELECTRIC WINDOWS
Electric windows
These systems operate:
- with the engine running;
- with the ignition off until one of the front doors is opened (limited to approximately 12 minutes).
- with the engine off, front doors closed, after pressing the start button.
Press the window switch down or pull it up to lower or raise the window to the desired height: the rear windows do not open fully.
From the driver’s seat, use switch:
1 for the driver’s side;
2 for the front passenger side;
3 and 5 for the rear passenger windows.
From the passenger seats, use switch 6.
Safety of rear occupants
The driver can prevent operation of the rear electric windows by pressing switch 4. A confirmation message is displayed on the instrument panel.
Driver’s responsibility
Never leave your vehicle with the RENAULT card or key inside, and never leave a child, adult who is not self-sufficient or a pet, even for a short while. They may pose a risk to themselves or to others by starting the engine or activating equipment (such as the gear lever or electric windows). If any part of the body becomes trapped, reverse the direction of the window immediately by pressing the relevant switch.
Risk of serious injury.
Avoid resting any objects against a half-open window: there is a risk that the electric window could be damaged.
One-touch mode
This mode works in addition to the operation of the electric windows described previously.
Briefly press or pull the window switch fully: the window is fully lowered or raised. Pressing the switch again stops the window moving.
Note: if the window detects resistance when closing (e.g.: branch of a tree, etc.) it stops and then lowers again by a few centimetres.
Remote control window closing
(vehicles with 4 one-touch electric windows).
When you lock the doors from the outside, press the locking button on the RENAULTcard twice in quick succession, or on the driver’s door in hands-free mode, and all the windows will close automatically (and, depending on the vehicle, the sunroof).
It is recommended that the user only operates the system when the vehicle can be seen clearly and no one is inside.
Operating faults
In case of a fault when closing a window, the system reverts to normal mode: pull the switch as many times as necessary until the window closes completely, hold the switch (still on the closing side) for around one second, then completely lower then raise the window to reset the system.
If necessary, contact an approved Dealer.
When closing the windows, ensure that no part of the body (arm, hand, etc.) is protruding from the vehicle.
Risk of serious injury.
Manual window winder controls
Turn the handle 7.