REAR LIGHTS AND SIDE LIGHTS: replacing the bulbs
5-door version
Side light 3
Consult an approved dealer.
Access to the bulb holders 6 and 7
Open the boot, remove the cover 4 to access the screw 5 and undo it.
Remove the rear lights unit.
Direction indicator light 2
Turn bulb holder 7 a quarter of a turn and take out the bulb.
Bulb type: PY21W.
Brake light 1
Turn bulb holder 6 a quarter of a turn and take out the bulb.
Bulb type: P21W.
Refit the bulb holder and push the unit in fully until it locks in place.
Check that the light is properly locked in position.
Tighten the screw 5 and reposition the cover 4.
Reversing light
From the boot, unclip the cover on the interior trim of the boot lid 8 using a screwdriver or similar tool.
Turn bulb holder 9 a quarter of a turn and take out the bulb.
Bulb type: W16W.
Refitting
To refit, proceed in the reverse order, taking care not to damage the wiring.
High level brake light 10
Consult an approved dealer.
Halogen fog lights 11
The front bumper needs to be removed; consult an authorised dealer.
Bulb type: P21W.
LED fog lights 11
Consult an approved dealer.
The bulbs are under pressure and can break when replaced.
Risk of injury.
Number plate lights 12
- Unclip the light 12 using a tool such as a flat-blade screwdriver;
- remove the light cover to gain access to the bulb.
Bulb type: W5W.
Side repeaters 13 and welcome lighting 14
The wing mirror needs to be removed; consult an authorised dealer.
The bulbs are under pressure and can break when replaced.
Risk of injury.
Estate version
Brake light 1
Consult an approved dealer
Side light 3
Consult an approved dealer.
Access to the bulb-holder 6
Open the luggage compartment lid, remove the cover 4 to access the two screws 5 and undo them.
Remove the rear lights unit.
Direction indicator light 2
Turn bulb holder 6 a quarter of a turn and take out the bulb.
Bulb type: PY21W.
Reversing light
From the boot, unclip the cover on the interior trim of the boot lid 7 using a screwdriver or similar tool.
Turn bulb holder 8 a quarter of a turn and take out the bulb.
Bulb type: W16W.
Refitting
To refit, proceed in the reverse order, taking care not to damage the wiring.
Rear fog light 10
The front bumper needs to be removed; consult an authorised dealer.
Bulb type: P21W.
Rear fog light 9
Unclip the flap located under the rear bumper using a flat-blade screwdriver or similar. Access the bulb holder, then unscrew it by turning towards the centre of the vehicle.
Bulb type: P21W.
High level brake light 11
Consult an approved dealer.
Number plate lights 12
- Unclip the light 12 using a tool such as a flat-blade screwdriver;
- remove the light cover to gain access to the bulb.
Bulb type: W5W.
Side repeaters 13 and welcome lighting 14
The wing mirror needs to be removed; consult an authorised dealer.
The bulbs are under pressure and can break when replaced.
Risk of injury.
4-door version
Side light 3
Consult an approved dealer.
Access to the bulb holders 6 and 7
Open the boot, remove the cover 4 to access the screw 5 and undo it.
Remove the rear lights unit.
Direction indicator light 2
Turn bulb holder 7 a quarter of a turn and take out the bulb.
Bulb type: PY21W.
Brake light 1
Turn bulb holder 6 a quarter of a turn and take out the bulb.
Bulb type: P21W.
Refit the bulb holder and push the unit in fully until it locks in place.
Check that the light is properly locked in position.
Tighten the screw 5 and reposition the cover 4.
Reversing light
From the boot, unclip the cover on the interior trim of the boot lid 8 using a screwdriver or similar tool.
The bulbs are under pressure and can break when replaced.
Risk of injury.
Turn bulb holder 9 a quarter of a turn and take out the bulb.
Bulb type: W16W.
Refitting
To refit, proceed in the reverse order, taking care not to damage the wiring.
High level brake light 10
Consult an approved dealer.
Halogen fog lights 11
The front bumper needs to be removed; consult an authorised dealer.
Bulb type: P21W.
LED fog lights 11
Consult an approved dealer.
Number plate lights with conventional bulbs 12
(depending on vehicle)
- Unclip the light 12 using a tool such as a flat-blade screwdriver;
- remove the light cover to gain access to the bulb.
Bulb type: W5W.
LED number plate lights 13
(depending on vehicle)
Consult an approved dealer
Side repeaters 14 and welcome lighting 15
The wing mirror needs to be removed; consult an authorised dealer.
The bulbs are under pressure and can break when replaced.
Risk of injury.