Front seats with manual control

  • 1
  • 2
  • 3
  • 4
  • 5

Front seats with manual control

To move the seat forwards or back

Raise the handle 1 to unlock. Release the handle at the desired position and make sure that it is locked.

Adjusting the lumbar support on the driver’s seat

(depending on the vehicle)
Push the switch 2 forwards or backwards to adjust the lumbar pad.

To raise or lower the seat base

Move lever 3 as many times as necessary upwards or downwards.

To tilt the seatback

Raise the handle 4 as far as possible and tilt the seatback to the desired position. Release the handle at the desired position and make sure that it is locked.
WARNING
After making adjustments, make sure that the seatbacks are correctly locked in place.
WARNING
For safety reasons, carry out any adjustments while the vehicle is stationary.
We would advise you not to recline the seatbacks too far to ensure that the effectiveness of the seat belts is not reduced.
Nothing should be placed on the floor (area in front of the driver) as these objects may slide under the pedals during sudden braking manoeuvres, thus obstructing their use.

Heated seats

Depending on the vehicle, with the ignition on, you can activate the heated seats via the multimedia screen 5:
  • pressing the pictogram on the required seat for the first time activates the heating system at maximum power. Three switch-integrated warning lights are illuminated;
  • a second press decreases the heating to medium power. Two integrated warning lights are illuminated;
  • a third press decreases the heating to minimum power. One integrated warning light is illuminated;
  • a fourth press turns the heating off.
In order to avoid unnecessary energy consumption, the heated passenger seat can be deactivated automatically in the absence of an occupant.

"Favourites" function

Depending on the vehicle, by pressing the steering wheel control 6, you can activate the heated seats according to the stored user settings that you have previously defined.
For more information on programming this function, please refer to the multimedia instructions.