Back to the list

Opaque panoramic roof

  • 1
  • 2
  • 3
  • 4
  • 5

Opaque panoramic roof

The panoramic roof made of opaque glass is divided into two sections (front and rear).
It can become totally opaque or completely transparent. You can also make only one area opaque (front or rear).
Each transition or transition request is accompanied by an animation representing the roof.

Operation

To make the entire roof opaque or transparent, press and hold switch 1.
To change one of the sections (front or rear) to opaque or transparent mode, press briefly on switch 1 as many as times as required.
Note: before pressing switch 1 again, you must wait for the previously selected action to be completed.
Depending on the vehicle, it is also possible to operate the vehicle by voice command. Please refer to the multimedia instructions for more information.
Tip
The roof becomes completely opaque after the doors are locked or the vehicle goes on standby (with the doors unlocked and the engine off, the instrument panel and/or multimedia screen switch off).
Tip
When the instrument panel and multimedia screen are switched on (welcome sequence) or when the engine start/stop button is pressed, the roof adopts the setting stored before the vehicle was last put on standby or when the doors were locked.

Limits of operation

In very cold weather conditions, the panoramic roof may have limited operation (reduced movement) or may not work at all.