Back to the list

Tyre inflation kit

  • 1
  • 2
  • 3
  • 4
  • 5

Tyre inflation kit

WARNING
The kit repairs tyres when the tread A has been damaged by objects smaller than 6 mm. It cannot repair all types of puncture, such as cuts larger than 6 mm, cuts in the tyre sidewall B, etc.
Ensure also that the wheel rim is in good condition.
Do not pull out the foreign body causing the puncture if it is still in the tyre.
WARNING
Do not attempt to use the inflation kit if the tyre has been damaged as a result of driving with a puncture.
You should therefore carefully check the condition of the tyre sidewalls before any operation.
Driving with underinflated, flat or punctured tyres can be dangerous and may make the tyre impossible to repair.
This repair is temporary.
A tyre which has been punctured should always be inspected (and repaired, where possible) by a specialist as soon as possible.
When taking a tyre which has been repaired using this kit to be replaced, you must inform the specialist.
When driving, vibration may be felt due to the presence of the repair product injected into the tyre.
WARNING
The kit is only approved for inflating the tyres of the vehicle originally equipped with the kit.
It must never be used to inflate the tyres of another vehicle, or any other inflatable object (rubber ring, rubber boat, etc.).
Avoid spillage on skin when handling the repair product bottle. If droplets do leak out, rinse them off with plenty of water.
Keep the repair kit away from children.
Do not dispose of the empty bottle in the countryside. Return it to your approved dealer or to a recycling organisation.
The bottle has a limited service life which is indicated on its label. Check the expiry date.
Contact an approved dealer to replace the inflation tube and repair product bottle.
In the event of a puncture, use the kit located in the boot.
Tip
Vehicle fitted with a tyre pressure loss warning system
In the event of under-inflation (punctures, etc.), the warning light appears on the instrument panel TYRE PRESSURE LOSS WARNING.
With the engine running and the parking brake applied:
  • disconnect any accessories that are connected to the vehicle's accessories sockets;
  • on vehicles fitted with a towing device, disconnect the towbar socket if needed;
  • see the information on the inflation kit compressor located in the vehicle luggage compartment and follow the instructions for use;
  • inflate the tyre to the recommended pressure TYRES;
  • after a maximum of 15 minutes, stop inflating and read the pressure (on the pressure gauge 2);
Note: while the container is emptying (approximately 30 seconds), the pressure gauge 2 will briefly indicate a pressure value up to 6 bar, then the pressure will fall.
  • Adjust the pressure: to increase it, continue inflating using the kit. To reduce it, press the button 1.
If the recommended pressure of 1.8 bar cannot be achieved after 15 minutes, repair is impossible. Do not drive the vehicle. Consult an authorised dealer.
WARNING
Before using this kit, park the vehicle at a sufficient distance from traffic, switch on the hazard warning lights, apply the handbrake, ask all passengers to leave the vehicle and keep them away from traffic.
WARNING
If the vehicle is parked on the hard shoulder, you must warn other road users of your vehicle's presence with a warning triangle or with other devices as per the legislation applying to the country you are in.
Once the tyre is correctly inflated, remove the kit: slowly unscrew the inflation adapter from the container 3 to prevent any product spatter, then store the container in plastic packaging to prevent the product from leaking.
  • Affix the driving recommendation label (located under the container) to the dashboard where the driver can see it.
  • Put the kit away.
  • At the end of this initial inflation operation, air will still escape from the tyre. You must drive a short distance in order to seal the hole.
  • Start immediately and drive at a speed between 12 to 37 mph (20 to 60 km/h) in order to distribute the product evenly in the tyre. After driving a distance of 2 miles (3 km), stop and check the pressure.
  • If the pressure is higher than 1.3 bar but lower than the recommended pressure (refer to the label affixed to the edge of the driver's door), adjust it. Otherwise, contact an approved dealer: the tyre cannot be repaired.

Precautions when using the kit

The kit should not be operated for more than 15 consecutive minutes.
The container must be replaced after the first use even if liquid remains inside.
WARNING
Nothing should be placed around the driver’s feet as during sudden braking such objects may slide under the pedals and obstruct their use.
WARNING
Please be aware that a poorly tightened or missing valve cap can make the tyres less airtight and may lead to pressure loss.
Always use valve caps identical to the originals and screw them down fully.
WARNING
Following repair with the kit, do not travel further than 124 miles (200 km).
In addition, reduce your speed and under no circumstances exceed 50 mph (80 km/h). The sticker, which you must affix in a prominent position on the dashboard, reminds you of this.
Depending on the country or local legislation, a tyre repaired with the inflation kit will need to be replaced.

tyre inflation kit