Back to the list

Blind spot warning

  • 1
  • 2
  • 3
  • 4
  • 5

Blind spot warning

Special feature

WARNING
This function is an additional driving aid. This function is not under any circumstances intended to replace the due care and attention of the driver, who should at all times be in control of the vehicle.
Using information from the ultrasonic sensors fitted on each side of the bumpers (zone B), the system notifies the driver when another vehicle appears in the detection zone A.
The system is activated when the vehicle speed is between 19 mph (30 km/h) and 105 mph (170 km/h).
Ensure that the ultrasonic sensor zonesB and C on each side of the bumpers are not obscured (by dirt, mud, snow, etc.).
If one of the ultrasonic sensors is obscured, the "Side radars no visibility" message is displayed on the instrument panel. Clean the ultrasonic sensor zones.

Activation/deactivation

Activating, deactivating alerts using the "My Safety" button 1

The alerts can be deactivated or activated using "Custom" mode in the "My Safety" function MY SAFETY.
If the alerts have previously been deactivated using Custom mode:
  • to deactivate the alerts, press the button 1 twice. The indicator light on the button 1 goes out;
  • to reactivate alerts, press the button 1 once. The indicator light on the button 1 lights up.

Activating and deactivating the alerts from the multimedia screen 2

To activate or deactivate the function, refer to the multimedia instructions.
Select "ON" or "OFF".

Vehicles not fitted with a multimedia screen

With the vehicle stationary, to deactivate/activate the function:
  • press the switch 3 as many times as required to reach the "" tab or, depending on the vehicle, the "" tab;
or
  • press switch 3 and repeatedly press control 4 or 5 to reach the  tab;
  • depending on the vehicle, press the switch 6OK;
  • repeatedly press control 4 or 5 to reach the menu, then press the switch 6OK;
  • repeatedly press control 4 or 5 to reach the "DRIVING AIDS" menu, then press the switch 6OK;
  • repeatedly press control 4 or 5 to reach the "Blind spot warning" menu, then press switch 6OK;
  • press switch 6OK again to activate or deactivate the function:
    • function activated;
    • function deactivated.

Warning light 6

A warning light 6 is located on each door mirror 7.
Note: clean the door mirrors 7 regularly so that the warning lights 6 remain visible.

Operation

The function alerts you if your vehicle speed is between approximately 19 mph (30 km/h) and 112 mph (180 km/h) while another vehicle is in the blind spot A and moving in the same direction as your vehicle;
If you overtake another vehicle, the indicator light 6 will only come on if that vehicle remains for a long enough period in your vehicle's blind spot A.

Operating faults

If the system detects a fault, the "Check Side radars" message is displayed on the instrument panel. Consult an approved dealer.

Display D

First warning: if the direction indicator is not activated, the warning light 6 indicates that a vehicle is detected in the blind spot A and/or that a vehicle is rapidly approaching from the rear in an adjacent lane.
Tip
Due to the presence of ultrasonic sensors behind the bumper, it is advisable to entrust any operation on the bumper (repair, replacement, paintwork etc.) to a qualified professional.

Display E

If the direction indicator is activated, the warning light 6 flashes when the function detects a vehicle or cyclist in zone A.
If you deactivate the direction indicator, the function will return to the initial warning (display D).
Note: the alert function is based on information from the radar. In certain situations (traffic jams, etc.), it may alert any type of moving object that is in zone A.

Conditions for non-function

  • When driving on a road with tight bends;
  • in reverse.
If the vehicle is equipped with a towbar recognised by the system, the "Trailer: blind spot warning off" message is displayed on the instrument panel to inform you that the function is not operational. For information on the range of equipment adapted to your vehicle, we advise you to consult an approved Dealer.
Tip
Then, according to the length of time following the last time the engine was stopped, the function is reactivated:
  • when the vehicle is unlocked;
or
  • when a door is opened;
or
  • when the engine is restarted.
WARNING
  • The system’s detection range operates according to a standard lane width. If you are driving in wide traffic lanes, the system might not be able to detect a vehicle in the blind spot.
  • In the event of very bad weather conditions (heavy rain, snow, etc.), the system may be temporarily disrupted. Remain aware of driving conditions.
There is a risk of accidents.

Warning

WARNING
This function is an additional driving aid. This function is not under any circumstances intended to replace the due care and attention of the driver, who should at all times be in control of the vehicle.
The driver should always adapt their speed to the traffic conditions, regardless of the system indications.
The system should under no circumstances be taken to be an obstacle detector or an anti-collision system.
System servicing/repairs
  • In the event of an impact, the alignment of the ultrasonic sensors may be altered and its operation may consequently be affected. Deactivate the function and consult an authorised dealer.
  • Any work in the area where the ultrasonic sensors are located (repairs, replacements etc.) must be carried out by a qualified professional.
Only an authorised dealer is qualified to service the system.
System disturbance
Some conditions can disturb or damage the system's operation, such as:
  • complex surroundings (metal bridges, tunnels, roads with barriers at the edge, etc.);
  • poor weather conditions (snow, hail, black ice, etc.).
Risk of false alarms or absence of warnings
In the event of the system behaving abnormally, deactivate it and contact an authorised dealer.
WARNING
Limitation of the system operation
  • The ultrasonic detection zones should be kept clean and free of any modifications in order to ensure the proper operation of the system.
  • Small objects moving close to the vehicle (motorcycles, bicycles, pedestrians, etc.) may not be recognised by the system.
  • When turning into a bend, the ultrasonic sensors may temporarily cease to detect vehicles in adjacent lanes.
  • The function may warn you late when two other vehicles are approaching from the rear, side by side in the adjacent lanes (driving on a 3-lane road) and at a much higher speed than your vehicle.
  • The system may not provide a warning when the other vehicles are travelling at a significantly different speed.
  • If the vehicle is being overtaken by a long vehicle (e.g. heavy goods vehicle overtaking at a similar speed to the vehicle) the system may interrupt the warning before the end of the manoeuvre.
  • The vehicle is travelling on a winding road.
Deactivating the function
You must deactivate the function if:
  • the radar area has been damaged (rear bumper);
  • the vehicle is fitted with a towbar that is not recognised by the system.