ELECTRIC WINDOWS
Electric windows
Press or pull the switch to raise or lower a window to the desired height (the rear windows do not open fully);
These systems operate with the ignition on or off, until one of the front doors is opened (limited to about 3 minutes).
From the driver’s seat, use switch:
1 for the driver’s side;
2 for the front passenger side;
3 and 5 for the rear passenger windows.
From the passenger seats, use switch 6.
Note: if the window detects resistance when closing (e.g.: branch of a tree, etc.) it stops and then lowers again by a few centimetres.
Safety of rear occupants
The driver can prevent operation of the rear electric windows by pressing switch 4. A confirmation message is displayed on the instrument panel.
Driver’s responsibility
Never leave your vehicle with the card inside, when there is a child, dependent adult or a pet on-board, even for a short while. They may pose a risk to themselves or to others by starting the engine or activating equipment (such as the gear lever or electric windows). If any part of the body becomes trapped, reverse the direction of the window immediately by pressing the relevant switch.
Risk of serious injury.
Avoid resting any objects against a half-open window: there is a risk that the electric window could be damaged.
One-touch mode
(depending on vehicle)
This mode works in addition to the operation of the electric windows described previously. It can be fitted to the driver’s window.
Briefly press or pull the window switch fully: the window is fully lowered or raised. Pressing the switch again stops the window moving.
Impossible to operate the one-touch electric window
The one-touch electric window is equipped with heat protection: if you press the switch for the window more than sixteen consecutive times it goes into protection mode (locking the window).
You can:
- use the electric window switch briefly and with intervals of approximately 30 seconds;
- with the engine running, the window will be unlocked after approximately 20 minutes of inaction on the electric window switch.
Note: if the window detects resistance when closing (e.g.: branch of a tree, etc.) it stops and then lowers again by a few centimetres.
Operating faults
If a fault occurs when closing a window, the system switches to normal mode: lift the switch concerned as many times as necessary until the window is fully closed, release it. Press the switch again (still on the closing side) for approximately one second to reset the system.
If necessary, contact an approved Dealer.
When closing the windows, ensure that no part of the body (arm, hand, etc.) is protruding from the vehicle.
Risk of serious injury.
Manual window winder controls
Turn handle 8.