FRONT SEATS
To move the seat forwards or back
Lift handle 1 to unlock. Release the handle once the seat is in the correct position and ensure that the seat is fully locked into position.
To adjust the lumbar support on the driver’s seat
(depending on vehicle)
Lower handle 2 to increase the support and lift it to decrease it.
To tilt the seatback
Turn control knob 3 to the required position.
After making adjustments, make sure that the seatbacks are correctly locked in place
For safety reasons, carry out any adjustments when the vehicle is not being driven.
We would advise you not to recline the seatbacks too far to ensure that the effectiveness of the seat belts is not reduced.
No object should be placed on the floor (in front of the driver). Nothing should be placed around the driver’s feet as such objects may slide under the pedals during sudden braking manoeuvres and obstruct their use.
Heated seats
With the ignition on:
- Pressing the switch 4 on the required seat for the first time activates the heating system on high. Both integrated switch warning lights come on;
- pressing the switch for the second time changes the heating to low. One integrated warning light comes on;
- pressing for the third time turns the heating off.
Operating faults
When an operating fault is detected, the warning lights in the 4 switch for the seat concerned switch off after approximately five seconds.
Consult an approved dealer.
USING THE STEERING COLUMN CONTROLS
