Back to the list

HEADLIGHT BEAM ADJUSTMENT

  • 1
  • 2
  • 3
  • 4
  • 5

Switch A is used to adjust the height of the headlight beams according to the load.

With the dipped beam headlights lit, press or lift switch A as many times as is necessary to select the required position on the instrument panel. The position selected is displayed on the instrument panel for approximately 30 seconds.

Note: lights on, at each engine start-up the selected position is displayed on the instrument panel for approximately 30 seconds.

Examples of positions for adjusting control A according to the load

Driver alone or with front passenger

0

All seats occupied

1

Driver with passengers and luggage (or load) reaching the maximum permissible all-up weight

2

Driver without passengers and luggage (or load) reaching the maximum permissible all-up weight

3

* depending on the vehicle

The table below gives some examples. In all cases, adjust control A according to the vehicle load so that the road can be seen and other drivers are not dazzled.

If driving on the left in a left-hand drive vehicle (or vice versa), drivers must have the lights adjusted by an authorised dealer for the duration of the trip.