Back to the list

360° CAMERA

  • 1
  • 2
  • 3
  • 4
  • 5

“360° camera” menu

Introduction

The vehicle is fitted with four cameras fitted at the front, in the side door mirrors and at the rear of the vehicle to offer you additional aid during difficult manoeuvres.

For further information, please refer to the “360° view camera” section in the vehicle user manual.

Note: Make sure that the cameras are not obscured (by dirt, mud, snow, etc.).

Operation

You can activate the system by pressing the activation button located in your vehicle, or by engaging the reverse gear (up to approximately five seconds after shifting to another gear).

A view of the area around the rear of the vehicle is displayed in zone A of the multimedia system screen 1, accompanied by a silhouette of the vehicle and sound signals.

Ultrasonic sensors installed in your vehicle “measure” the distance between the vehicle and an obstacle.

When the red zone is reached, use the bumper image to stop accurately.

A bird’s eye view of the vehicle and its surroundings is displayed in zone B on the multimedia system screen.

For further information, please refer to the “360° view camera” section in the vehicle user manual.

The screen shows a reverse image.

The gauges are a representation projected onto flat ground. This information must not be taken into account when superimposed on a vertical object or an object on the ground.

Objects which appear on the edge of the screen may be deformed.

In very bright light (snow, vehicle in sunshine, etc.), the camera vision may be adversely affected.

Settings

From the main menu, select “Settings” then the “Vehicle” tab, then “Parking assistance” followed by “Camera”. Use this menu to configure the 360° camera:

- press “ONˮ or “OFFˮ to activate or deactivate the guiding lines;

- press “+ˮ or “-ˮ to adjust the brightness, contrast and colours of the image.

Camera choice

You can also select the view of zone B displayed on the multimedia screen by selecting a view type:

- 360° view of the surroundings 2;

- passenger side 3;

- obstacle detection 4.

From the pop-up menu 5, you can return to the default settings.

This function is an additional aid which indicates other vehicles in the blind spot area. It can never in any case be a substitute for care nor for the driver’s responsibility while in charge of his vehicle.

The driver should always be ready for sudden incidents while driving: always ensure that there are no small, narrow moving obstacles (such as a child, animal, pushchair, bicycle, stone, post, etc.) in the blind spot when manoeuvring.