Back to the list

Wiper blades: replacement

  • 1
  • 2
  • 3
  • 4
  • 5

Wiper blades: replacement

Replacing windscreen wiper blades 2

Access

To access the wiper blades, stand on the foot panel 1.
Note: the foot panel may be slippery.

Removal

To replace the wipers, first put them in the service position B.
With the ignition on and the engine stopped:
  • move the stalk 1 twice in succession to position A (single sweep): the wiper blades will stop in the service position B away from the bonnet;
  • lift the wiper arm 3;
  • lower the tab 4 and remove the blade 2.

Refitting

To refit the wiper blade 2, insert it into its housing in the arm 3, then clip it until you hear a click. Make sure that the blade is correctly locked in position.
To return the blades to the lowered position, make sure that the blades are folded down onto the windscreen then set the stalk 1 to position A (single sweep): the windscreen wiper blades will fold into the bonnet when the ignition is switched on.
Tip
Check the condition of the wiper blades. You are responsible for their service life:
  • clean the blades and the windscreen regularly with soap and water;
  • do not use them when the windscreen is dry;
  • free them from the windscreen when they have not been used for a long time.
WARNING
  • In frosty weather, make sure that the wiper blades are not stuck by ice (to avoid the risk of the motor overheating).
  • Check the condition of the wiper blades. Replace the wiper blades as soon as they begin to lose efficiency (approximately once a year).
Whilst changing the blade, take care not to drop the arm onto the window after it has been removed as this may break the window.