Ignition switch

  • 1
  • 2
  • 3
  • 4
  • 5

Ignition switch

"Stop and steering lock" position St

To lock: remove the key and turn the steering wheel until the steering column locks.
To unlock: turn the key and the steering wheel slightly.

"On" position M

With the ignition on, the engine will be preheating.

"Start" position D

If the engine fails to start at the first attempt, turn the key back before activating the starter again. Release the key as soon as the engine starts or, depending on the vehicle, when the "READY" message is displayed on the instrument panel.
Note: after turning the key, it may take a few seconds for the engine to be pre-heated before it starts.

Special note on vehicles with an automatic gearbox

Press the brake pedal with the lever in N position.
Note: if a gear other than neutral is displayed, it flashes; starting is not possible unless you press the brake pedal while holding the key in the starting position.
Tip
In the "On" position, a system may automatically switch off your vehicle’s accessories, depending on the battery charge level, to prevent it from discharging completely.