Back to the list

Headlight beam adjustment

  • 1
  • 2
  • 3
  • 4
  • 5

Headlight beam adjustment

Operation

Depending on the vehicle, switch A can be used to adjust the height of headlight beams according to the load.
With the dipped beam headlights on, press or raise switch A as many times as required to select the required position on the instrument panel. The position selected is displayed on the instrument panel for approximately 15 seconds.
Note: if the lights are on, at each engine start-up the selected position is displayed on the instrument panel for approximately 15 seconds.
Tip
When driving on the left in a left-hand drive vehicle (or vice versa), you must adjust your lights temporarily for the duration of your trip.

Table of adjustment position examples

 
Examples of positions for adjusting the control Aaccording to the load
Driver only
0
Driver alone with a front passenger
1 or 2
All seats occupied
1 or 2
Driver with passengers and luggage (or load) reaching the maximum permissible all-up weight
2 or 3
Driver without passengers and luggage (or load) reaching the maximum permissible all-up weight
2 or 3 or 4
The table below gives some examples. In all cases, adjust the control A according to the vehicle load so that the road can be seen and other drivers are not dazzled.

lights and adaptive lighting system