Back to the list

Wheel trims, wheel trim – wheel

  • 1
  • 2
  • 3
  • 4
  • 5

Wheel trims, wheel trim – wheel

Wheel trims

Central wheel trim 3

Remove it using the hubcap tool 1 (located in the tool kit), fitting the hook into the notch 2 on the central wheel trim 3.
To refit the central hubcap:
  • position it so that the symbol 4 (located on the rear side of the hubcap) is aligned with and facing the valve of wheel 5;
  • clip it on by pressing the central part of the hubcap 3;
  • Check that it is correctly locked in place.

Wheel trim 6

Remove it using the hubcap tool 1 (located in the tool kit), engaging the hook in the opening near the valve 2.
To refit it, align it with the valve 2.
Push the retaining hooks in fully, starting on the side of the valve A, then B and C and finishing at the side opposite the valve D.
WARNING
Do not leave the tools unsecured inside the vehicle as they may be projected during braking.
After use, check that all the tools are correctly clipped into the tool kit, then position it correctly in its housing to reduce the risk of injury.