REAR BENCH SEAT
To manually fold down the seatbacks
Ensure that the front seats are far enough forward.
Raise the side headrests to the highest position and lower the central headrest fully.
Depending on the vehicle, put the seat belt in the belt guide 2 to avoid damaging it, or buckle it its own unit. This will prevent the seat belt becoming trapped when the seat is returned to its position for use. In all cases, check that the seat belts are operating correctly.
Pull the control 1 and lower the seatback A.
To replace the seatback, proceed in the reverse order to removal.
Refit the seatback and click it back into place.
For safety reasons, carry out any adjustments when the vehicle is not being driven.
The configuration of the two-seat bench with the small seatback B pulled down, does not allow the central seat to be used as it would be impossible to buckle the seat belt (belt buckles inaccessible).
When refitting the seatback, make sure it is correctly locked in place.
If seat covers are fitted, make sure these do not prevent the seatback latch from locking in.
Make sure that the seat belts are positioned correctly.
Reposition the headrests.
When moving the rear seats, ensure that nothing obstructs the anchorage points (passenger’s arm or leg, a pet, gravel, cloth, toys, etc.).
To automatically fold down the seatbacks (flat position)
(Estate version)
From the boot, pulling the control 3 enables you to automatically unlock the rear bench seatbacks to get a flat floor.
Conditions of use
- Vehicle stationary;
- luggage compartment lid open;
- rear seat belts locked.
Operating faults
If all user conditions have been fulfilled and the folding action still fails to operate, please contact an authorised dealer.
When moving the rear seats, ensure that nothing obstructs the anchorage points (passenger’s arm or leg, a pet, gravel, cloth, toys, etc.).