Back to the list

Exterior lighting: replacing bulbs

  • 1
  • 2
  • 3
  • 4
  • 5

Exterior lighting: replacing bulbs

WARNING
Before carrying out any action in the engine compartment, you must switch off the ignition STARTING, STOPPING THE ENGINE.
WARNING
The bulbs are under pressure and may break when replaced.
Risk of injury.
WARNING
Please note when working close to the engine that it may be hot. The engine cooling fan may also start at any moment. The label in the engine compartment reminds you of this.
Risk of injury.
WARNING
Any operation on (or modification to) the electrical system must be performed by an approved Dealer since an incorrect connection might damage the electrical equipment (harness, components and in particular the alternator). In addition, your Dealer has all the parts required for fitting these units.
Tip
To comply with local legislation, or as a precaution, you can obtain an emergency kit containing a set of spare bulbs and fuses from an approved dealer.

Front headlights

Dipped beam headlights

Remove the cover B and unclip the bulb holder 2.
Bulb type: H7LL
Do not touch the bulb glass. Hold it by its base.
Note: once the bulb has been replaced, ensure the cover is positioned correctly.

Main beam headlights

Remove the cover A and unclip the bulb holder 1.
Bulb type: H1.
Note: once the bulb has been replaced, ensure the cover is positioned correctly.

Direction indicators

Turn the bulb holder 3 a quarter turn to the left.
To refit, turn the bulb holder a quarter turn to the right.
Bulb type: PY21W.

LED side lights, daytime running lights 4

Consult an approved dealer.

Front fog lights 5

  • Unscrew the wheel arch liner 6 using a flat-blade screwdriver or similar tool;
  • access the bulb holder located behind the bumper, via the wheel arch liner;
  • unscrew the bulb holder.
Bulb type: H16LL

Rear and indicator lights

Rear lights

Depending on the vehicle, remove the protective grilles. Loosen the two nuts 1 and pull the rear lights unit A.
Loosen the bolts 2 using a flat-blade screwdriver or similar tool to remove the bulb holder 3.
4.
Side light and brake light
Pear-shaped, bayonet type bulb with two filaments P21/5W
5.
Indicator light
Orange pear-shaped, bayonet type bulb PY21W
6.
Reversing light
Pear-shaped, bayonet type bulb P21W
7.
Fog light
Pear-shaped, bayonet type bulb P21W

High-level brake light

Remove the cover 8.
Unscrew the nut.
Remove the unit from outside the vehicle to access the bulb 9.
Bulb type: W16W

Number plate lights

Unclip the light 10 (using a tool such as a flat-blade screwdriver).
Remove the light cover to gain access to the bulb.
Bulb type: W5W

Side indicator lights

Move the mirror 11 to access the bolt.
Undo the bolt using a Torx screwdriver.
Take out the indicator light and replace the bulb 12.
Bulb type (depending on vehicle): WY5W or W16W

Clearance lights

Push the light 13 (movement B) and press C to remove the light.
Turn the bulb holder a quarter of a turn and replace the bulb.
Bulb type: W5W