Back to the list

Rear headrests

  • 1
  • 2
  • 3
  • 4
  • 5

Rear headrests

Position for use

Lift the headrest fully until it locks. Check that the bonnet is correctly locked.

To remove the headrest

Tilt the bench seat forwards, raise the headrest as much as possible, then press button 1 and remove the headrest.

To refit the headrest

Tilt the bench seat forwards, then insert the rods into the holes, push in the headrest until it locks to use it in the high position. Check that the bonnet is correctly locked.

Headrest folding position 2

Press button 1 and lower the headrest completely.
When the headrest is set at the lowest position, this is for storage only: it should not be in this position when the seat is occupied.
WARNING
The headrest is a safety component; check that it is fitted and in the correct position.