Headlight beam adjustment
Headlight beam adjustment
Switch A is used to adjust the height of the headlight beams according to
the load.
With the dipped beam headlights lit, press or lift switch A as many times as
is necessary to select the required position on the instrument panel.
Note : depending on the vehicle, at each engine start-up the position selected is
displayed on the instrument panel for approximately 30 seconds and 5 seconds after
each
press of switch A.
Examples of position:
Thermal vehicle
- 0
- Driver alone or with a front passenger
- 1
- All the seats are occupied
- 2 or 3*
- Driver with passengers and luggage (or load) reaching the maximum permissible all-up weight
- 4
- Driver without passengers and luggage (or load) reaching the maximum permissible all-up weight
* depending on the vehicle
Hybrid vehicle
- 0
- Driver alone or with a front passenger
- 1
- All the seats are occupied
- 1 or 2
- Driver with passengers and luggage (or load) reaching the maximum permissible all-up weight
- 2 or 3
- Driver without passengers and luggage (or load) reaching the maximum permissible all-up weight
This gives some examples. In all cases, adjust control A according to the
vehicle load so that the road can be seen and other drivers are not dazzled.