Back to the list

EXTERNAL LIGHTING AND SIGNALS

  • 1
  • 2
  • 3
  • 4
  • 5

u Side lights

Turn the end of stalk 1 until the symbol is opposite mark 2.

The instrument panel will light up.

k Dipped beam headlights

Manual operation

Turn the end of stalk 1 until the symbol is opposite mark 2. This indicator light on the instrument panel comes on.

Automatic operation

(depending on vehicle)

With the engine running, the dipped beam headlights are switched on or off automatically depending on the level of ambient light, without the need to operate stalk 1.

This function can be deactivated or reactivated.

- To activate: with the ignition on and the vehicle stationary, press and hold button 3 for at least four seconds. Depending on the vehicle, the message “lights ON” appears on the instrument panel.

- To deactivate: with the ignition on and the vehicle stationary, press and hold button 3 for at least four seconds. Depending on the vehicle, the message “lights OFF” appears on the instrument panel.

á Main beam headlights

With stalk 1 in dipped beam headlights position, move the stalk towards you. The indicator light on the instrument panel then lights up.

To return to the dipped beam headlight position, pull the stalk towards you again.

Before driving at night, check that the electrical equipment is operating correctly and adjust the headlight beams (if your vehicle is not carrying its normal load). As a general precaution, check that the lights are not obscured (by dirt, mud, snow or objects being transported).

“See-me-home lighting” function

(depending on vehicle)

This function (useful, for example, when opening a gate, garage, etc.) enables you to switch the dipped headlights on momentarily.

With the ignition off and the headlights off, pull stalk 1 towards you: the dipped beam headlights come on for approximately sixty seconds.

This action may be carried out no more than four times for a maximum lighting period of four minutes.

To switch off the lights before they switch off automatically, turn the end of stalk 1 then bring it back to position 0, or switch on the ignition.

e Switching off the lights

There are two possibilities:

- manually, move stalk 1 to its original position;

- automatically, the lights are switched off when the engine is stopped, the driver’s door is opened or, depending on the vehicle, when the vehicle is locked. In this case, the next time the engine is started the lights will be switched back on according to the position of the ring 2.

g Front fog lights

(depending on vehicle)

The side lights or dipped beam headlights must be on.

Turn ring 5 on stalk 1 until the symbol is opposite mark 4, then release it. This indicator light on the instrument panel comes on.

Rear fog light

The front fog lights and the side lights or dipped beam headlights must be on.

Turn ring 5 on stalk 1 until the symbol is opposite mark 4, then release it. This indicator light on the instrument panel comes on.

To avoid inconveniencing other road users, remember to switch off the rear fog light when it is no longer needed.

Switching off the lights

Turn ring 5 again to position mark 4 opposite the symbol for the light you wish to switch off.

Switching off the exterior lights or the ignition switches off the front and rear fog lights.

Lights-on reminder buzzer

A warning beep sounds when the driver’s door is opened to warn you that the lights are still on.