TRIP COMPUTER AND WARNING SYSTEM: journey parameters

  • 1
  • 2
  • 3
  • 4
  • 5

The display of information shown below DEPENDS ON THE VEHICLE EQUIPMENT AND COUNTRY.

Examples of selections

Interpreting the display selected

Vehicle Systems OK

a) Trip log.

Successive display:

- information messages (passenger airbag OFF etc.);

- operating fault messages (Check injection etc.).

b) Current fuel consumption.

This value is displayed after a speed of approximately 20 mph (30 km/h) is reached.

7.4 L/100

Average fuel consumption since the last reset.

The value is displayed after having travelled at least 400 metres since the last reset.

5.8 L/100

c) Trip mileage recorder: distance travelled since the last reset.

112,4 km

Average speed since the last reset.

The value is displayed after driving 400 metres.

123.4 km/h

Examples of selections

Interpreting the display selected

Tyre pressure init. long press

d) Reset the tyre pressure.

TYRE PRESSURE LOSS WARNING

16:30

e) Setting the time.

CLOCK AND EXTERIOR TEMPERATURE

Examples of selections

Interpreting the display selected

On-board computer with mileage-before-service message

f) Service distance.

Mileage before service

With the ignition on and engine not running, access the “Mileage before service” information. When the distance value approaches its limit, there are several possible scenarios:

- If the range is less than 930 miles (1,500 km) or one month: the message “Service due” is displayed accompanied by the nearest term (distance or time);

- range equal to 0 miles (0 km) or date of service reached: the message “Service Required” is displayed accompanied by the warning light ©.

The vehicle requires a service as soon as possible.

Service in

25 000 km/12 months

Service due in

300 km / 24 days

Service Required

Reset: to reset the distance before the next service, press and hold the OK button for approximately 10 seconds until the display shows the mileage before service permanently.

Note: if a service is performed without changing the engine oil, only the mileage before the next service should be reset. In the event of an oil change, both the distance before the next service and the next oil change should be reset.

Examples of selections

Interpreting the display selected

On-board computer with distance before next service message (cntd.)

f) Service distance.

Mileage before service

With the ignition on and the engine not running, access the mileage information to display the mileage before the next oil change.

Oil change in

25 000 km/24 months

Depending on the vehicle, the mileage before an oil change varies according to the driving style (frequent driving at low speed, door-to-door journeys, extensive use at idling speed, towing a trailer, etc.). The distance remaining until the next oil change can therefore decrease more quickly in some cases than the actual distance travelled.

Reset: to reset the distance before the next service, press and hold the OK button for approximately 10 seconds until the display shows the mileage before oil change permanently.

Note: if a service is performed without changing the engine oil, only the mileage before the next service should be reset. In the event of an oil change, both the distance before the next service and the next oil change should be reset.

Top Up AdBlue before 2400 km

g) Estimated range with remaining reagent.