Card

Make sure that the correct battery type is being used, and that the battery is in good condition and inserted correctly. Its service life is approximately two years : it should be replaced when the message “Keycard Battery Low” appears on the instrument panel HANDS-FREE CARD: BATTERY.

This varies according to the environment : take care not to accidentally lock or unlock the vehicle by inadvertently pressing the buttons on the card.

Note : if a door or the boot is open or not properly shut, locking is not carried out. A beep sounds and the hazard warning lights and side repeaters do not flash.

Pressing button 4 switches on the dipped beam headlights and the exterior lighting for approximately 20 seconds. This can be used, for example, to identify the vehicle from a distance when parked in a car park.

Pressing and holding the 4 button for approximately two seconds activates the exterior lighting and a sound is emitted.

Note : pressing button 4 again switches off the lighting.

Interference by factors in the immediate vicinity (external installations or the use of equipment operating on the same frequency as the card) may disrupt its operation.

Slide the rear casing 5 downwards while pressing on zone A.

Insert the hand strap into the 8 component and pass the end of the strap through the buckle.

Position the strap at the 6 opening and close the cartridge.

Note : check that the diameter of the strap cord 7 will fit the opening 6.

There are three ways to unlock/lock the vehicle :

Depending on the vehicle, you can deactivate/activate :

You can also disable/activate the sound signal that is emitted upon locking when moving away from the vehicle. VEHICLE SETTINGS CUSTOMISATION MENU

With the card in access zone 3, the vehicle will unlock. Unlocking is indicated by one flash of the hazard warning lights and the indicator lights.

With the card on you, doors and luggage compartment door closed, move away from the vehicle : it will lock automatically once you have left the access zone 3.

Note : the distance at which the vehicle locks depends on the surroundings.

To indicate that the vehicle has been locked, the hazard warning lights flash twice and then light up for approximately four seconds, and a beep sounds in confirmation.

If the card has been within the detection area 3 for approximately 15 minutes, remote locking is disabled. To lock the vehicle, press the 2 button on the 1 handle depending on the vehicle or the 5 button on the card.

The vehicle cannot be locked with hands-free locking if the card is within the area 4.

With the card in zone 3 and the vehicle locked, press the button 2 on the handle 1 of one of the two front doors depending on the vehicle : the vehicle unlocks. Press the button 2 also unlocks all the doors and the tailgate.

The hazard lights and side repeaters flash once to indicate that the doors have unlocked and, on some vehicles, the door mirrors fold out automatically.

Pressing the 2 button again locks the vehicle.

The hazard warning lights flash twice to indicate that the vehicle is locked and, depending on the vehicle, the door mirrors automatically fold in.

In certain circumstances, approach unlocking is disabled :

Press button 2 (front door handle) or use the remote control card you (refer to the following pages) to unlock the vehicle and reactivate hands-free mode.

After locking in “hands-free” mode, you have to wait approximately three seconds before being able to unlock the vehicle again. During these three seconds, the door handles can be tried to make sure that the vehicle is locked properly.

Note : if a door or the boot is open or not properly shut, locking is not carried out. A beep sounds and the hazard warning lights and side repeaters do not flash.

Press button 7.

The hazard lights and side repeaters flash once to indicate that the doors have unlocked and, on some vehicles, the door mirrors fold out automatically.

With the doors and boot closed, press button 5 : the vehicle locks.

The hazard warning lights flash twice to indicate that the vehicle is locked and, depending on the vehicle, the door mirrors automatically fold in.

Pressing the 5 button twice locks the vehicle and enables the closure of the front and rear windows (depending on the vehicle).

If, while the engine is running, a door is opened and closed, and the card is no longer in the zone 4, the message “Keycard Not Detected” indicates that the card is not inside the vehicle. This will, for example, prevent you from driving away after dropping off a passenger who has kept the card on them.

The warning disappears when the card is detected again.

Press the button 6 to lock/unlock the boot only.

If the vehicle is equipped with a deadlocking function, this allows you to lock the opening elements and to prevent the doors from being unlocked using the interior handles (for example, by breaking the window and then trying to open the door from the inside).

To do this, press button 2 twice in quick succession.

Locking is confirmed by two slow flashes and three quick flashes of the hazard warning lights and indicator lights.

Special note : deadlocking is not possible if the hazard warning lights or the side lights are lit.

Unlock the vehicle using button 1 on the card.

Unlocking is indicated by one flash of the hazard warning lights and indicator lights.

When the message “Keycard Battery Low” appears on the instrument panel, replace the battery in the card :

When refitting, proceed in the reverse order, then press one of the buttons on the card four times, close to the vehicle : the next time the vehicle is started, the message will disappear.

Check that the cover is clipped shut.

Note : do not touch the electronic circuit or contacts on the card when replacing the battery.

If the battery is too weak to ensure correct operation, you will still be able to start and lock/unlock the vehicle LOCKING, UNLOCKING THE OPENING ELEMENTS AND DOORS.